Baileigh roll bender. Rolling coils is one of the hardest thing to do inn metal forming. This is where the bender comes in and makes easy work of the job. The bender from Baileigh is the perfect ring and angle roll bender for doing small diameter material or coils because of its tight compact roll formation. Lateral guides are also adjustable, making it easy to bend just about any width coil imaginable. Rolling operation on the bender is done via a set of foot pedals for forward and reverse roll direction. An emergency stop is also integrated for safety. An easy to read digital display, shows the top roll position to make repeatability a snap. Like all Baileigh roll benders the bender is built to last and includes a rugged steel frame and hardened ground and polished high strength steel shafts. The bender head can be removed from the included stand to make this roll bender portable. This would be especially important if going to a job site or just to have extra room in the shop. Another nice feature of the bender is that it is available in 110 Volts three phase, allowing anyone form someone working out of their garage to a big industrial fabricating shop. Specifications: round tube capacity: size: 1-inches (0.0625-inches) minimum diameter: 16-inches; shaft center distance lower rolls: 10.88-inches; shaft diameter: 0.78-inches; upper roll diameter: 3.38-inches; roll adjustment: manual; lower roll diameter: 3.38-inches; solid round capacity: size: 0.5-inches minimum, diameter: 5-inches; pipe capacity: size: .5-inches (sch.40)/minimum diameter: 14-inches; pinch: single; square tube capacity: 0.75-inches (0.0625-inches) minimum diameter: 12-inches; angle iron capacity: size: 0.75-inches (0.125-inches) minimum diameter: 10-inches; flat bar easy way: size: 1.75-inches minimum diameter: 12-inches; flat bar hard way: size: 1-inches minimum diameter: 8-inches; driven rolls: 2 and power: 110 Volts 3-phase.